Page 2
I N I N I N I N I N THE INTEREST OF SAFETY THE INTEREST OF SAFETY THE INTEREST OF SAFETY THE INTEREST OF SAFETY THE INTEREST OF SAFETY 5 5 5 5 5 BEFORE ST BEFORE ST BEFORE STA R BEFORE ST BEFORE ST A RTING ENGINE,...
Read all safety and operating instructions before assembling or starting this unit. PUT OIL IN ENGINE BEFORE STARTING Your Billy Goat is shipped from the factory in one carton, completely assembled except for the upper handle, debris bag, and bag quick disconnect.
LITERATURE ASSY P/N 890322 12 12 12 12 14 14 14 14 INSTRUCTION LABELS These labels should be included on your Vacuum. If any of these labels are damaged, replace them before putting this equipment into operation. Item and part numbers are given to help in ordering replacement labels..
Operation 16 16 16 16 INTENDED USE: This machine is designed for vacuuming leaves, grass clippings and other types of organic litter and for chipping brush, limbs, corn and sunflower stalks and palm fronds. Debris mixed with cans, bottles and small amounts of sand can be vacuumed;...
Page 6
OPERATION 16 16 16 16 continued Note: Dry wood is (fig. 2) harder to chip than green wood. (SP model shown) 1 6 . 1 6 . 1 6 .9 9 9 9 9 MULCH 1 6 . 1 6 . Wood chips made from branches in your own yard make excellent mulch.
Page 7
OPERATION continued 16 16 16 16 TAMPER 1 6 .12 1 6 . 1 6 . 1 6 . 1 6 . 12 12 Before turning machine off, use the Tamper to slowly push remaining pieces of wood through the chipper. This can prevent any remaining wood from jamming in the chipper when machine is turned off.
Note: The chipper blade gap is factory set and should be checked each time impeller is removed from engine crankshaft and reset if required. If reassembly requires a different quantity of shim washers, Billy Goat shim washer must be used. ®...
MAINTENANCE 17 17 17 17 continued IMPELLER REMOVAL continued 17.1 17.1 17.1 17.1 17.1 19. If chipper blade properly clears anvil surface, proceed to step 20. If not, return to (step 14) and add or subtract shim washers as needed to obtain a correct gap. 20.
22 22 22 22 Please fill in the WARRANTY CARD and send the upper part to Billy Goat. The WARRANTY terms are stated on the lower part which remains with the user. Whenever a Billy Goat Machine is faulty due to a defect in material...