Connecting Your Monitor; Turning On The Monitor And Computer - Sony SDM-X53 Operating Instructions (primary manual) Quick Setup Manual

Connecting your monitor

Connect your monitor to a computer or other equipment.
• Turn off the monitor, computer, and any other
equipment before connecting them.
• Do not touch the pins of the video signal cable plug.
1
Slide up the back cover.
2
Tilt the display forward.
3
Connect your monitor to a computer.
Connecting a Macintosh computer
Connect the supplied video signal cable to a video output connector
on the computer. If necessary, use an adapter (not supplied). Connect
the adapter to the computer before connecting the video signal cable.
4
Connect the supplied power cord to the monitor's
AC IN connector.
5
Connect the power cord to a power outlet.
2
.
to the HD15 input
connector (analog RGB)
INPUT 1 INPUT 2
AUDIO 1 HD-15 AUDIO 1
audio cord
(supplied)
HD15-HD15 video signal
cable (analog RGB)
(supplied)
4
to AC IN
to power outlet
5
power cord (supplied)
Note
For bundling the cords and cables, refer to the Operating Instructions on
the supplied CD-ROM.
back cover
1
to the DVI-D input
connector (digital RGB)
INPUT 3
HD-15 AUDIO DVI-D
IN
3
DVI-D video
signal cable
(digital RGB)
(supplied)
The rear of the display
describes SDM-X73.
SDM-X53 has one
HD15 input connector.
Turning on the monitor and
computer
Turn on your monitor first, then a computer.
1
Press the MAIN POWER switch on the right side of
the monitor in the direction of the [, if it is not
already pressed. Make sure the 1 ( power) indicator
is lit in red.
Note
The default setting of the MAIN POWER switch is in the direction of
the [.
2
Press the 1 (power) switch on the front right of the
monitor.
The 1 (power) indicator lights up in green.
3
Turn on the computer.
1
MAIN POWER
2
3
(US)
US