Connecting Your Monitor's Speaker - Sony Trinitron CPD-100GS Operating Instructions Manual

Connecting Your Monitor's
Speaker
You can listen to music, sounds, and other audio files using
the speaker in your monitor.
Connect the AUDIO IN jack to the audio out jack of your
computer's sound card using the miniplug cord (supplied).
AUDIO
IN
AUDIO IN jack
Adjusting the sound
1
Press the MENU button.
The MENU OSD appears.
MENU
2
Press the ¨./> and >?// buttons to select "™
SOUND," and press the MENU button again.
The SOUND OSD appears.
Note
While muting the sound, the
instead of the Á mark. Increase the volume to cancel the
and activate the speaker.
2 Headphones jack
MENU OK
MENU
COLOR CENTER SCREEN
GEOM EXIT ZOOM
SOUND SIZE OPTION
SOUND
26
mark appears in the SOUND OSD
mark
Getting Started
3 Press the >?// buttons to adjust the volume.
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on.
To mute the sound
Press the MUTING button.
No sound comes from the speaker.
The mark appears at the bottom of the screen.
MUTING
To cancel, press the MUTING button again.
Using the headphones jack
You can listen to the audio signals from your computer
using headphones (not supplied). The speaker turns off
when headphones are connected to the headphones jack.
Adjust the volume using the SOUND OSD.
Note
If the volume from the speaker is too low, increase the output level
(average of 500 mv) of the computer.
Getting Started
7
EN
F
ES
C