Expedition; List Of Requirements For Expedition; Transport And Handling Of Parts; Storing - Remak AeroMaster FP Series Service Instructions Manual

Expedition

List of requirements for expedition

To every air handling FP unit belong:
Accompanying technical documentation.

Trade technical documentation with scheme of unit

FP installation.
Device service book.

Connecting kit

Mounting kit

Separate elements of measuring and regulation, or

accessories according to the bill of delivery

Transport and handling of parts

FP units are delivered to customers (to place of installa-
tion) as separate blocks according to suggestion in the
project. Blocks are set on transport palletes of appropri-
ate dimensions and secured from moving by belting.
Loading or unloading is done by forklift truck or by hand
pallet truck.
The forks of the forklift truck must be set so, that they
reached over the whole length of section and so that it
was forked for the whole length.
During transportation or handling it is necessary to pay
attention to elements sticking out of sides of section (pi-
pes, wiring elements, sensors, motor spindles).
It´s necessary to be especially careful when lifting it up
and putting it down.

Storing

Storing means storage of wrapped units delivered by
producer for period longer then 30 days.
Units are placed on transport pallets, wrapped in PE foil
and protected by polystyrene protections.
They must be stored at places where:
maximal relative air humidity doesn´t exceed 85%

and without humidity condensation
surrounding temperature ranges from -20°C up to

+40°C
no dust, gasses and corrosive fumes or other che-

mical matters causing corrosion of constructional parts
and device equipment may get into the device.

Placing

FP units are standardly installed in horizontal suspen-
ded position - under the ceiling.
The units can also be installed in lying horizontal positi-
on (on prepared basement).
Picture 2 – suspension under the ceiling
4
Air handling units
Picture 3 – installation on a basement (floor)
Units with cooling or heat recovery can not be installed
in horizontal position on the floor.
Unit installation in vertical position requires producing
of special frame (which is not part of delivery). Separate
sections are attached to this frame using clips.
When choosing place for installation it is necessary to
follow these requirements:
sufficient space for connection of needed installation

sufficient space for right installation of unit

sufficient space for attendance and service of unit,

change of separate parts in case of failure.
Distances between surrounding parts and air hand-
ling unit result from inside dimensions of casettes and
from elements of connecting fittings. Recommended
distances can be visualized in program AeroCAD. Side
distance should not be smaller then 400 mm.