Usa Cable Connections - Stern Pinball WHOA NELLIE! BIG JUICY MELONS Service And Operation Manual

GAME SETUP
FIRST-TIME SETUP CONTINUED

1.6 USA CABLE CONNECTIONS

Making cable connection from base game to backbox
Make sure the backbox has been properly attached to the base game
Reach into the base cabinet through the large rectangular hole in the backbox and retrieve the bundle of cables. Pull the
bundle into the back box
RJ45 cable
Connect the four cables from the base cabinet to the matching cables in the backbox, these are the white connectors.
There is: a 3 pin plug, 4 pin plug, 6 pin plug, and 12 pin plug.
There are two black RJ 45 cables one gets connected to the CPU the other to the 4-coil driver circuit board.
The ribbon cable gets connected to the CPU
The ground strap to the stud as shown
10
Ground Strap
RJ45 cable goes here
WHOA NELLIE! MANUAL #780-50D7-00
white connector cables
3 pin, 4 pin, 6 pin, 12 pin
Ribbon Cable
RJ45 cable
Loosen 4 nuts-do not remove
Slide CPU up and off
Run ribbon cable behind CPU
as shown
Place CPU back on studs
Tighten nuts
Connect ribbon connector
Note location of stripe
RJ45 cable goes here
Remove nut with 11/32 driver
Connect ground strap
Replace nut
756-6238-00
MANUFACTURED UNDER LICENSE BY STERN PINBALL, INC.
™ & © 2015 WHIZBANG PINBALL LLC. ALL RIGHTS RESERVED.