Figure 30. Open the hinges
Step 4.
Remove the LCD module from the upper case in the direction shown.
Figure 31. Remove the LCD module
CAUTION:
Do not pull up the upper case before disconnecting the LCD cable. Otherwise the cable may
be damaged.
Remove the I/O board
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 31
"Remove the battery pack" on page 32
"Remove the LCD module" on page 44
Step 1.
Disconnect the cable of the I/O board as shown.
.
Chapter 4
Removing a FRU or CRU
45