Remove The I/O Bracket (Right); Remove The I/O Board With Cable - Lenovo 21A200M2IX Hardware Maintenance Manual

I/O bracket (left)

Remove the I/O bracket (right)

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 32
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove two screws and then remove the I/O bracket (right).
Figure 23. Remove two screws and remove the I/O bracket (right)
Screw specifications
M2.0 x L4.0
Go to https://support.lenovo.com/partslookup
part:
I/O bracket (right)

Remove the I/O board with cable

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 32
"Remove the battery pack" on page 33
"Remove the fans" on page 40
"Remove the CMOS battery" on page 41
"Remove the I/O bracket (right)" on page 43
Step 1. Remove three screws and then open the hinge.
Number of screws
2
to look up the Lenovo part number of the following replacement
.
Chapter 4 Removing a FRU or CRU
43