Page 1
User and Operating Instructions ------------------------------------------ 3 WARNINGS Nortek Global HVAC (UK) Ltd equipment must be installed and maintained in accordance with the relevant provisions of the Gas Safety (Installations and Use) Regulations 1998 for gas fired products. Due account should also be taken of any obligations arising from the Health and Safety at Works Act 1974 or relevant codes of practice.
Page 2
Health and Safety For your own safety we recommend the use of safety boots and leather faced gloves when Nortek gas fired heaters must be installed in handling sharp or heavy items. The use of accordance with the relevant provisions of the protective eye wear is also recommended.
2. Assembly Instructions. PLEASE READ this section prior to Please ensure that all packaging is assembly to familiarise yourself with the disposed of in a safe environmentally components and tools you require at the friendly way. various stages of assembly. Carefully open the packaging and check the contents against the For your own safety we recommend the parts and check list.
Page 4
2.2.6 Burner Heat Exchanger Assembly. Slide the burner assembly onto the RIGHT HAND TUBE when viewed from above, ensuring it is fully engaged. Slide heat exchanger onto the LEFT HAND TUBE when viewed from above, ensuring it is fully engaged. The hose connections should face vertically.
Page 5
VSX3M VSX3M VSX2M VSX4M VSX2M VSX4M COLOUR CODE 30/35/40/ COLOUR CODE 30/35/40/ 20/25/30 45/50 20/25/30 45/50 Full Nut Washer Washer Full Nut M6 x 35 M6 x 15 Setpin Setpin Prior to assembly • Ensure the area in which you are working is safe and clear of obstructions. •...
Page 6
Locate and insert turbulator(s) into tube(s) ensuring the correct length and quantity are inserted into the correct tube. See assembly drawings section for location & length. CAUTION — SHARP EDGES! 2.5.2 Brackets, U Bolts and U bend. Fit the M8 U bolts over the tubes into the holes in the bracket &...
Page 7
2.5.3 Reflectors. Remove protective film before starting. Reflectors are supplied pre-punched and are universal throughout the VSX series. Starting at the burner end, slide the reflectors through the brackets until they are all roughly in position along the heater, referring to the assembly diagram showing overlaps.
Locate M4 pins, washers & nuts into holes in overlapping reflectors as shown. 2.5.4 End Caps Using M4 setpins & washers fix the blank end cap beneath the reflector profile at the U bend end with the flanges facing outwards. Using M4 setpins &...
2.5.6 Canopy End Caps Locate 6 off No.5 torque screws. Position the blank canopy end cap with the end cap flanges facing inwards, beneath the canopy profile at the U bend end & fix with screws. Repeat procedure for 'cut-out' canopy end cap, again ensuring the flange faces inwards.
Registered in England No. 1390934. Registered office: 10 Norwich Street, London, EC4A 1BD Nortek Global HVAC is a registered trademark of Nortek Global HVAC Limited. Because of continuous product innovation, Nortek Global HVAC reserves the right to change product specification without due notice.