Assembly - Sage Kitchen Wizz Pro BFP800 Quick Manual

ASSEMBLY

BEFORE FIRST USE
Before using your Sage food processor,
®
become familiar with all the parts. Remove all
packaging materials and promotional labels,
being careful when handling the processing
blades and discs as they are very sharp. Wash
the processing bowl, processing lid and other
attachments in warm, soapy water. Rinse and
dry thoroughly. (Refer to cleaning, care and
storage section).
1. Place the motor base on a dry, level work
surface. Place the processing bowl on
to the motor base with the handle in line
with the ALIGN HANDLE graphic on
the motor base.
2. Turn the processing bowl clockwise
until the handle aligns with the
TURN TO LOCK graphic.
The processing bowl should
be securely locked into position.
8
3. If using a disc, first assemble the disc
spindle onto the bowl drive coupling.
Orientate the disc so that the side you
wish to use is facing upwards. Hold
the disc by the centre plastic moulding
and position the central hole above the
attachment spindle. Push down firmly
until fitted correctly.
(Please note that these discs only fit the
larger processing bowl).
4. For using the processing blades, carefully
grasp either the 4 blade processor, dough
blade or mini processing blade using
the central plastic support and position
it over the bowl drive coupling and push
down until inserted correctly. If using the
mini processing blade, ensure the mini
processing bowl is assembled into the
main bowl first.
ASSEMBLY
5. Place the processing lid onto the
processing bowl so the feed chute is
slightly right of the bowl handle and the
arrow graphics are aligned .
Holding the feed chute and pressing
down firmly at the same time, turn the lid
clockwise (as indicated by the graphic)
so the 'Locking Tab' on the lid slots into
the 'Interlocking Safety Catch' on the
handle. The lid should be securely locked
into position.
NOTE
The food processor will not operate
unless both the processing bowl and
lid are correctly locked into position.
CAUTION
The processing blade (including
the mini bowl blade) and discs are
extremely sharp, handle with care
at all times.
6. Insert the power plug into a 220–240 volt
power outlet and switch the power
outlet on.
7. At the end of processing, always wait until
the blades or discs have stopped spinning
before unlocking and removing the lid.
To remove the processing lid, ensure the
POWER / OFF button has been pressed,
the power is switched off at the power
outlet and the cord is unplugged from the
power outlet. Holding the feed chute and
pressing down firmly at the same time,
turn the lid anti-clockwise so that the
arrow graphics are no longer aligned.
8. Remove the processing bowl (before
removing blade or discs) by turning it
anti-clockwise until the handle is in line
with the ALIGN HANDLE. Lift the bowl
off the motor shaft. When removing the
discs – carefully remove by gripping the
plastic hub on the centre of the disc and
lifting the disc up and away from the pin
on the spindle.
OVERLOAD PROTECTION SYSTEM
If the motor overloads, the food processor will go
to STANDBY mode and OVERLOAD icon in the
LCD starts to flash. The food processor can still
be switched off by pressing the POWER / OFF
button. To operate the food processor again,
allow the machine to cool for approx 30 minutes.
Some stiff mixtures, such as dough, may cause
the dough blade to rotate more slowly than
normal. If this happens, do not process for
longer than 1 minute.
EN
9