Table of Contents
Advertisement
6.6 Multimeter to measure dc voltage
● Using automatic (AUTO) to measure dc voltage
① Long press "PRW" button, then press "F5"
multimeter into the interface(Or if the oscilloscope
in other functional interface, long press "MENU" -> "F5" )
② Press the "F1" button to select "dc voltage".
③ The multimeter pens and the dc voltage under test.
As shown in figure 6-8
The seventh
Chapter
7.1 Message system
SAVEING：When stored waveform or screenshot, the system will have the prompt show, and in the
middle of the screen has a progress bar.
CLOSING: After startup when long press "PRW", when the battery is too low, or when to
oscilloscope set off time, system will have the hint, and in the middle of the screen has a
progress bar.
USER1 RUNNING:Waveform signal generator can run
USER3 NO FILE:Signal generator no waveform file
System prompts and troubleshooting
71
Figure 6-8 DC voltage
Advertisement
Table of Contents
