To Capture A Single Signal - Jinhan JHJDS3012A Manual

(1)Press the "HORI" button to enter the main base state of the cursor Settings.
(2)Press "F1" button sets the cursor type to "voltage", press "F2" button to set the source to
the CH1.
(3)Through the cursor display window to see the cursor 1 and 2 cursor location (relative to the
middle of zero voltage reference is horizontal) and delta (the cursor 2 - light the
differential pressure after 1).
(4)By " "," "button to adjust the position of the cursor 2" ", " " buttons to adjust
the position of the cursor 1; And the position of their change and incremental will update the
display the cursor display window in real time. As shown in figure 6-2, 6-3

6.3 To capture a single signal

Figure 6-3 cursor measure
Figure 6-2 cursor to measure
66