Table of Contents
Advertisement
（1）Press the "AUTO" button, can quickly measure the current waveform.
（2）Page, according to the CH1 button that can be observed frequency and peak values.
At this point, the frequency and peak values measured values are displayed on the screen on the
right side position. As shown in figure 6-1
6.2 The cursor measurement
The digital storage oscilloscope can be
automatically measured a variety of
waveform parameters. All of the automatic
measurement parameters can be measured
by the cursor. Use the cursor can be
quickly on the waveform on time and voltage
measurements.
Measuring the square wave signal peak voltage
●
CH1 channels, for example, to measure the square-wave signal peak voltage, please click the
following steps:
Figure 6-1 square wave
65
Advertisement
Table of Contents
