Table of Contents
Advertisement
B. Valve Bracket and Shutoff Valve
Installation
Valve bracket can be used when mounting the shutoff valve
or by itself or can be directly attached by screwing it to the
table in provided mounting holes. See Figure 5.5.
Shuto Valve
Figure 5.5
Valve Bracket
Figure 5.6
Complete Burner Pan Starter Kit
12
Outdoor Lifestyles • ODPLAZA-L24S Installation Manual • 4079-311 • Rev B • 04/19
C. Burner Extension Installation Instructions
1. When connecting burner pans together, use the brackets
supplied with burner extension kit (ODPLAZA-L24E).
Each kit will allow installation of one extension. Up to
four burner extensions may be used.
Valve Bracket
Figure 5.7
1 - Extension pan
2 - Screw pack
3 - Flexline bulkhead orifice
4 - Extension brackets
5 - Nat orifice
6 - Adapter 1/2 NPT to 3/8 flare
2. When connecting a burner extension to a starter kit you
must create a manifold to supply gas to each extension.
Manifold can be made of 1/2 inch black iron pipe and will
need a pipe "T" and a drop for each additional burner
section. Manifold will need to be built to accommodate
quantity of burner extensions used.
3. Attach adapter 1/2 in. NPT to 3/8 in. flare to the manifold.
Connect flex line to the 1/2 in. NPT 3/8 in. flare adapter.
4. When installing multiple burner extensions, a separate
valve (VK-ODPLAZA) must be installed for everything
over 65,000 BTU of burner, (for example, a 10 ft. burner
would require (3) three separate valves, an 8 ft., (2) two
valves and a 4 ft.(1) one valve).
1
6
5
2
3
Extension Kit (ODPLAZA-L24E)
Figure 5.8
Extension Kit Brackets
4
Advertisement
Table of Contents
