Communication Output Link - Siemens SICAM AK Manual

Redundancy via CP-6010
2.6.2.3.2

Communication Output Link

After creating the signals, select LNK_1703_SDFR and make necessary changes for
configuring as communication output link.
Select the parameter
menu.
Select the parameter
Select the parameter
Select the parameter
different depending on the used configuration.
Select the parameter
This must be the station number specified in the connection definition of
Settings.
These signals can be used for priority voting. You can configure different type of errors as
input signal and can assign to priority signals by using CAEx plus.
122
as Selective data flow routing
Lk_Cat
as Activated via the relevant pull-down menu.
Lk_Prep
as selective
Selectivity
as PRE1 via the relevant pull-down menu. This value can be
PRE
as 8 and
Station_A Station_B
Unrestricted
via the relevant pull-down
via the relevant pull-down menu.
as 9 via the relevant pull-down menu.
System-Technical
SICAM RTUs, SICAM AK Redundancy
Edition 10.2016, DC2-026-2.07