IBM e Server i Series Manual page 24

__ 24. Select Display non-configured units on the Display disk configuration
__ 25. The disk unit that you installed should be listed. The serial number should
__ 26. Press F12, twice.
__ 27. Select Work with disk configuration on the Work with Disk Units display.
__ 28. Are you adding a disk unit to an existing device parity set? If you need
__ 29. Select Include unit in device parity protection on the Work with disk
__ 30. Did the Include Device Parity Protection Failed display appear?
__ 31. The following conditions must be met before you can start device parity
__ 32. When the above conditions are met, select F12 to return to the Work with
__ 33. Select Include unit in device parity protection on the Work with disk
__ 34. Select the disk units to include in Device Parity Protection. Type a 1 in the
18
43xx Disk Unit, 71xx Disk Expansion Unit, 71xx Disk Unit Enclosure V5R3
Press Enter.
display.
Press Enter.
match the serial number you wrote in step 12 on page 16.
Note: The new disk unit may take up to five minutes to appear in the list.
If the disk unit is not listed, ensure that the disk unit was properly
installed. Repeat steps "Install 43xx disk units with system power
on" on page 15 through 19 on page 17.
Press Enter.
more information about device parity, go to Backup and Recovery
__ Yes: Continue with the next step.
__ No: Do you want to start a device parity set?
__ Yes: Go to Device parity protection in the Information Center.
__ No: Go to step 46 on page 19.
configuration display.
Press Enter.
__ Yes: Continue with the next step.
__ No: Go to step 34.
protection. Including the disk unit in device parity protection may fail for
one or more reasons.
v If there are enough disk units available to create a new parity set, the
units will be eligible for Start Device Parity Protection operation and not
for the Include Device Parity Protection operation. For more information,
go to Backup and Recovery
v All disk units in a parity set must be the same capacity with a
minimum number of 3 or 4 disk units and maximum of 10 or 18 units
in the resulting parity set, depending on the disk unit type.
v Not all disk units attached to an advanced function input/output
processor have reported to the system. Retry the operation.
v The type/model of the disk units must be supported for the requested
operation.
disk configuration display.
configuration display.
Press Enter.
Option column on the Include Disk Units in Device Parity Protection display.
Press Enter.
.
.