IBM e Server i Series Manual page 23

video.
__ 14. Support the disk unit assembly as you slide it half way into the system
unit or the expansion unit. Do not push it any further.
Note: You install the disk units horizontally in the 7123, 7136, and 7137
disk unit enclosure.
__ 15. Locate the light in the numbered arrow by the disk unit you are installing.
When you press Enter, after a one minute delay, the light comes on and
begins to blink rapidly. You then have nine seconds to slide the disk unit
all the way forward and push in the handle on the disk unit.
__ 16. Press Enter on the console.
__ 17. When the light starts blinking, slide the disk unit all the way in and lock it
in place by closing the latch.
__ 18. The light stops blinking and remains on when you have installed the disk
unit properly.
__ 19. Return to the console and wait until the Concurrent Maintenance Results
display appears.
Press Enter.
__ 20. Do you have another disk unit to install?
__ No: Continue with the next step.
__ Yes: Look at the front of the system unit or the expansion unit and
determine the next available position. Repeat steps 8 on page 16
through 19 to install the next disk unit.
__ 21. When the Hardware Service Manager display appears, press F12.
__ 22. Select Work with Disk Units on the System Service Tools display.
Press Enter.
__ 23. Select Display disk configuration on the Work with Disk Units display.
Chapter 3. Install 43xx disk units
17