CHAPTER 2 - TECHNICAL DATA
PXG200E Kit Contents
PXG200E CD-ROM Contents
Requirements for PXG200E Installation
6
EATON PXG200E User Manual • IM02603001E Rev 5, 11-May-2012 • Firmware Version 5.03:3835
Each PXG200E kit contains the following components:
•
PXG200E
•
Standard Panel Mounting Hardware
•
DIN Rail Adapter
•
PXG200E CD-ROM
PXG200E CD-ROM contains the following items:
•
USB driver
•
Supported Device List
•
Supported Device Data Maps (i.e., Modbus TCP Register Maps)
•
PDF copy of Eaton Electrical Field Devices Communication Wiring
Specification (TD 17513)
•
PDF copy of PXG200E User Manual
When you install a PXG200E you should have the following items available:
•
USB AB cable
Either of the following
•
•
CAT 5 STP*/UTP . *Based on the applications, STP may be necessary
for electromagnetic immunity requirements. A CAT 5 Ethernet LAN
cable is for connecting the PXG200E Ethernet LAN port to the
Ethernet LAN system, such as to a router or switch.
•
An Ethernet LAN Crossover cable. An Ethernet LAN Crossover cable
is for connecting the PXG200E Ethernet LAN port directly to the
Ethernet LAN port on your computer without connecting to the
network.
•
Cable for communications between the Modbus RTU and INCOM
devices and the PXG200E communications ports.
•
24 VDC Power Supply
•
Input Voltage, Nominal: 24 VDC; 0.8 A
•
Input Voltage Range: +/- 20% Nominal
NOTICE: The recommended power supply part number ELC-
PS02 is available and meets these requirements.
•
#1 Phillips Screwdriver - Required for the smaller Phillips screws in the
DIN rail adapter mounting hardware kit.
•
#2 Phillips Screwdriver - Required for the larger Phillips screws in the
DIN rail adapter mounting hardware kit.
•
0.5 x 3 mm (0.02 x 0.12 in) (thickness x width) Flathead Screwdriver -
Required for the wiring connectors.
RETURN