Sony SCD-XA333ES Operating Instructions Manual page 7

Connecting via DIGITAL (CD) OUT OPTICAL
connector
Use an optical digital cable for this connection. When connecting
the optical digital cable to the DIGITAL (CD) OUT OPTICAL
connector, take the cap off the connectors and push the cable
plugs in until they click into place.
Be careful not to bend or twist the optical cable.
Optical digital cable (not supplied)
Note
Only the audio signals of conventional CDs can be output from
the DIGITAL (CD) OUT connectors. Those of the Super Audio
CD cannot be output through DIGITAL (CD) OUT.
Connecting via DIGITAL (CD) OUT COAXIAL
connector
Use a coaxial digital cable to connect the audio components
equipped with coaxial digital input connectors.
Coaxial digital cable (not supplied)
Note
Only the audio signals of conventional CDs can be output from
the DIGITAL (CD) OUT connectors. Those of the Super Audio
CD cannot be output through DIGITAL (CD) OUT.
Connecting the mains lead (SCD-XA333ES
only)
Connect the mains lead to a wall outlet.
Connecting the mains lead (SCD-XA777ES
only)
Connect the supplied mains lead to the AC IN terminal on
the player and to the mains.
Note on the ANALOG output jacks (SCD-XA777ES
only)
This player is equipped with a Tri-Powered D/A Converter
System and a Multi Channel Management function. The usable
output settings differ depending on the mode you select as
follows. For details, refer to the Operating Instructions.
Multi Channel
Source
Managment
CD Not available when
playing back CDs
Super Audio CD Direct
(2 channel) 2ch + SW
Super Audio CD Direct
(Multi-channel) Except Direct
Note on 2 channel playback of Super Audio CDs
If you select "2ch + SW," the output setting becomes 3 channel
and the playback sound is output from the 5.1 CH OUT jacks.
Therefore, no sound is output from the 2 CH OUT jacks or
PHONES jack.
2CH OUT 5.1CH OUT PHONES
jacks jacks
jack
a a
a a
a
a
a
7
GB