Table of Contents
Advertisement
I. Quick Start Guide
The Quick Start Guide is a condensed version of the user guide for experienced users.
It does not replace the user guide.
1
Check the transport dimensions, floor load and fuses at the installation location..
4 See page 21 4 See drawing page 24
The Flightcase has four inner and four outer wheels.
2
The inner wheels must always have contact with the ground.
When transported on a tail lift, the four outer wheels can overhang.
4 See page 8
When the WOWMAKER has reached its designated location, first lift off the rear case and then the
3
front case. At least two people are required to remove the cases.
4 See page 9
Place both cases upright against each other on the floor and lock them against each other with
4
the butterfly locks.
4 See page 12
Check that all connections are plugged in and locked.
Connections to the socket strip:
• 1x Neutrik power cable
• 2x Neutrik plugs from the display
• S-Box power supply unit on socket strip
5
• 1x power cable for Lifter control
Connections S-Box:
• S-Box connection with power supply unit
• Network cable between S-Box and display
6
Lower the device's foot and bring the Lifter to the presentation height.
4 See page 11
7
Remove the slide-in panel and roll the floor of the case away to the front.
4 See page 12
The WOWMAKER is now ready for presentation and media from the S-Box's hard disk can be
shown on the display.
8
If desired, other media can be connected to the S-Box via cable.
4 See page 13
4 See page 25
4 See page 25
4 See page 25
4 See page 25
4 See page 25
4 See page 25
3
Advertisement
Table of Contents
