Table of Contents
Advertisement
XI. Important Information
Operate device indoors only!
Observe the load limits of the tail lift!
The Flightcase has four inner and four outer wheels (in some models with an additional middle
wheel). The inner wheels must always be in contact with the ground.
When transported on a tail lift, the outer four wheels can therefore overhang.
During transport, make sure that the Flightcase is not tilted laterally by more than 9°.
Installation may only be carried out at an angle of 3°!
At least two people are required to remove the cases. Otherwise there is a risk of accident.
Set the cases down carefully!
If the power supply is protected with 16A, the connector strip for both power circuits of the display
can be operated with the supplied Neutrik power cable. Alternatively, both display circuits can be
powered separately with 10A fuses!
Only lay cables (power, media, remote control cables) through the brush strip!
Make sure that the cables are not pinched!
Attention when lowering the foot plate! There is risk of being crushed!
The lower edge of the Studioframe must be higher than the upper edge of the "spare box"!
The connection of the display with the S-Box must be guaranteed via the HDBT1OUT connection
of the S-Box!
The rear slide-in panel must be inserted before lowering!
When lowering the display, make sure that the two locking bolts snap into the groove of the Studio-
lifter. Continue to lower until the foot plate is flush with the floor of the Flightcase!
Risk of crushing due to foot plate!
Lock the wheels of the Flightcase if the WOWMAKER is not to be moved!
Do not use cleaning agents with scouring milk or solvents!
18
Advertisement
Table of Contents
