Table of Contents
Advertisement
IX. Dismantling the WOWMAKER
Disconnect the signal cable. Roll the floor frame of the Flightcase to the front of the Studioframe and its
lifting columns. The recesses in the floor frame should surround the lifting columns. Replace the rear slide-
in panel.
ATTENTION: Rear slide-in panel must be inserted before lowering!
ATTENTION: When lowering the display, make sure that the two locking pins snap into the holes in
the Studiolifter. Then lower until the foot plate is flush with the floor of the Flightcase.
ATTENTION: Risk of crushing by the foot plate!
Recesses
Disconnect the Neutrik power cable and unlock the Neutrik plug with a 1/8 turn. Store the power cable and
the remote control in the internal cable box.
Replace and lock the case. The WOWMAKER is now ready for transport.
Locking pins
15
Holes
Advertisement
Table of Contents
