Caleg WOWMAKER M 130 General Operating Instructions page 20

Problem
NO VIDEO appears on the display
The position of the Lifter cannot be
changed
Columns do not run parallel or
out of sync
Incorrect display of the LED modules
or cabinet
Possible solution
The display has power, but no video signal.
4 See page 13
Check power supply..
4 See above: "WOWMAKER has no power"
4 Call caleg service: +49 6893 89 470
To do this, you must press the DOWN button
control (approx. 5 seconds) until all motors have reached the
lower end position. Continue to press the button for approx. 5
seconds.
4 Call SAMSUNG service: +49 3591 27 220
20
on the remote