What To Do If You Forget The Password - Leuze lumiflex ASM1E Connecting And Operating Instructions

Proceed as follows:
1. Disconnect the defective AS-i safety monitor from the supply.
2. Use the download cable (RJ45/RJ45) to connect the defective device to the
replacement device.
3. Apply the supply voltage to the replacement device.
4. The configuration of the defective device is now automatically transferred to the
replacement device.
Active transmission is indicated by the continuous illumination of the yellow
READY LED. Conclusion of a successful transmission is indicated by the conti-
nuous illumination of the yellow READY LED and the green ON LED.
5. Disconnect the new AS-i safety monitor from the supply and disconnect the
download cable from both devices. The replacement device can now directly be
used in the place of the defective device.
Attention!
After replacing a defective AS-i safety monitor, make certain to check the new AS-i
safety monitor for proper function.
10.6

What to do if you forget the password

Attention!
Only the responsible safety officer is permitted to retrieve a lost password in the way
described below!
If you have lost the password for your configuration, proceed as follows:
1. Find the valid configuration log (printout or file) of the AS-interface safety monitor
for which you no longer have a password. In the configuration log, find a four-digit
code in line 10 (Monitor Section, Validated).
• If the configuration log is unavailable and the AS-interface safety monitor is not
to be switched to configuration operation, connect the AS-interface safety
monitor for which you no longer have a password to the PC and start the
asimon software.
• Select a neutral configuration and start the diagnostic function in asimon with
Monitor → Diagnosis. Now wait until the current configuration appears on the
screen. This can take up to five minutes.
Open the Monitor-/Businformation window (menu item Edit → Information
•
about monitor and bus...). In the Information about monitor... tab you will
again find the four-digit code in the Download time window area.
2. Contact the technical support department of your supplier and state the four-digit
code.
3. A master password can be generated from this code. This password allows you to
access to the stored configuration again.
4. Use the master password to stop the AS-interface safety monitor and to enter a
new user password. To do so, select Change password... in the Monitor menu of
the asimon configuration software.
98 ASM1, ASM1E