Table of Contents
Advertisement
Notice!
The description of the asimon program can be found in the separate software user
manual.
Configuration operation (Chapter 8.1.2) is indicated by sequential illumination of LEDs
1 ... 3 of the output circuit 1.
Proceed as follows:
•
Install the program on your PC.
•
Apply the supply voltage to the AS-i safety monitor.
Notice!
We recommend that before the user inserts the parameterisation cable into the safety
monitor he perform a discharge (earthing) at a suitable location.
•
Use the interface cable (RJ45/SubD 9-pin) to connect the PC to the AS-i safety
monitor (see chapter 2.1.2 "Connection between the AS-i safety monitor and the
PC" of the software user manual).
•
Configure the AS-i safety monitor and put it into operation as described in the
software user manual.
•
The AS-i safety monitor is ready for operation following commissioning.
Attention!
Before commissioning the device you must adapt the device configuration to your
application. To do this, configure the AS-i safety monitor as described in the software
manual in such a way that the given danger area is protected by the device.
8.5
Technical safety documentation for the application
Notice!
The detailed description of the technical safety documentation for the configuration of
your application can be found in the separate software user manual.
Proceed as follows:
•
Create the AS-i safety monitor configuration for your application.
•
Validate the configuration (to be performed by the safety officer).
•
Print out the final configuration log and, optionally, the configuration overview (see
chapter 5.8 "Configuration documentation" of the software user manual).
•
Sign the final configuration log (to be performed by the safety officer).
•
File the log together with the other technical safety documentation for your
application (machine documentation) and store in a safe location.
94
ASM1, ASM1E
Advertisement
Table of Contents
