LED
2 ON
(per output circuit)
3 OFF/FAULT
(per output circuit)
1 READY
2 ON
3 OFF/FAULT
(per output circuit)
8.3
Switching on the device
As soon as the supply voltage is present at the device, the internal system test begins.
This operating status is indicated by the switching on of all LEDs installed in the device
(see chapter 8.1.1 "Start-up operation").
8.4
Device configuration and parameterisation
For the device configuration and parameterisation, you require the software program
asimon.
The asimon software is responsible for the following tasks:
•
Configuring the AS-i safety monitor
•
Documentation of the device configuration
•
Commissioning the AS-i safety monitor
•
Diagnosis of the AS-interface safety monitor
Colour
off
green,
continuous
green,
flashing
off
red,
continuous
red,
flashing
simultaneously
flashing rapidly
ASM1, ASM1E
Meaning
contacts of the output switching element open
contacts of the output switching element closed
delay time runs in event of Stop Category 1
contacts of the output switching element closed
contacts of the output switching element open
error on level of the monitored AS-i components
internal device error,
error message can be queried by means of
asimon software
93