To Start/Stop Recording In Sync With The Source Player (Synchro-Recording) - Sony MZ-B100 Operating Instructions (primary manual) Operating Instructions Manual

To start/stop recording
in sync with the source
player
(Synchro-recording)
You can easily make digital recordings of
a digital source on an MD.
Before synchro-recording, make
connections to the digital source with a
digital cable, and insert a recordable MD.
CD players,
etc.
zREC
1
Press REC MODE repeatedly until
"STEREO", "LP2", "LP4", or
"MONO" lights up in the display.
For details on the recording mode, see
"Recording for long times" (page 16).
2
Slide SYNCHRO REC to ON.
"SYNC" appears in the display.
30:03
Synchro-recording indication
"SYNC" doesn't appear if optical
cable is not connected to the LINE IN
(OPTICAL) jack on the recorder.
24
-GB
REC MODE
SYNCHRO REC
007
3
Press zREC.
The recorder stands by for recording.
4
Play the source sound.
The recorder starts recording when it
receives the playing sound.
To stop recording
Press xSTOP.
z
• You cannot pause manually during synchro-
recording.
• When there is no sound from the player for
more than 3 seconds during synchro-
recording, the recorder goes into the standby
mode automatically (page 53). When the
sound comes from the player again, the
recorder resumes synchro-recording. If the
recorder is kept in the standby mode for 5
minutes or longer, the recorder stops
automatically.
Notes
• Do not switch the SYNCHRO REC switch
after step 3. Recording may not be done
properly.
• The recording mode setting (stereo, LP2
stereo, stereo, or monaural)
LP4
changed during synchro-recording.
• Even when there is no recorded sound on the
sound source (page 53), there may be cases
when recording does not pause automatically
during synchro-recording due to the noise
level emitted from the sound source.
• If a silent portion is encountered for 2 seconds
or more during synchro-recording, a new track
mark is automatically added at the point
where the silent portion ends (page 53).
• Synchro-recording cannot be done if the
connecting cord is not an optical cable, or if
the cable is connected to the MIC (PLUG IN
POWER) jack.
• You cannot change the recording mode during
recording.
cannot be