To Start/Stop Recording In Sync With The Source Player (Synchro-Recording) - Sony MZ-R500 Analog PCLink Operating Instructions Manual

2
Press >MENU. repeatedly to
select the desired recording mode.
Recording Display
mode 1)
Stereo Stereo
LP2 stereo LP2
LP4 stereo LP4
2)
Monaural Mono
1)
For better sound quality, record in normal
stereo or LP2 mode.
2)
If you record a stereo source in monaural, the
sounds from left and right will be mixed.
3) When using an 80-minute recordable MD.
3
Press ENTER.
4
Press N while pressing REC.
The recording starts.
5
Play the source sound.
To stop recording, press x.
The settings of the recording mode
remains when you record the next time.
z
• Audio components that support the LP2 or
LP4 modes are indicated by the
logo marks.
• Once you set, the recorder keeps its recording
mode when you record the next time.
Notes
• You cannot change the recording mode while
recording.
• It is recommended that you use the AC power
adaptor for long recordings.
• If you try to play an MD recorded in LP2 or
LP4 on a player/recorder that is not support
these modes, playback will not start and "LP:"
will appear on the display.
• Sound recorded through digital (optical) input
can be monitored in stereo through
headphones/earphones, etc.
Recording
time 3)
80 min.
160 min.
320 min.
160 min.
or
• When you record in LP4 mode, momentary
noise may be produced on very rare occasions
with certain sound sources. This is because of
the special digital audio compression
technology that enables a recording time 4
times longer than normal. If noise is produced,
it is recommended that you record in normal
stereo or LP2 mode to obtain better sound
quality.
To start/stop recording
in sync with the source
player
(Synchro-recording)
You can easily make digital recordings of
a digital source on an MD.
Before synchro-recording, make
connections to the digital source with a
digital cable, and insert a recordable MD.
CD players,
etc.
REC
N
>MENU.
1
Press ENTER while the recorder is
stopped.
ENTER
continued
17
-GB