Start Screen 'Basic Settings; Change The Basic Settings Of The Device - IFM Electronic Ecomat 300 AC422S Original Device Manual

ifm Original Device Manual Fail-safe SmartPLC with EtherNet/IP interface (AC422S), Firmware 4.0.2
Setup
>
7.3

Start screen 'Basic settings'

The 'Basic settings' start screen appears after the following actions/events:

initial setup

firmware update

data loss due to battery failure
The basic settings provide access to the GUI texts, system time, etc.
The same operating notes as for the page view apply for the 'Basic settings' start screen
Page view
(→
>
7.3.1

Change the basic settings of the device

To change the basic settings of the device:
1 Start the device
► Connect the device to a circuit.
> The device starts.
> The display shows the start screen "Basic settings"
(picture).
2 Set the language of the GUI texts
► The list shows the active language.
► Use [] / []to select the list.
> The focus (= orange frame) is on the selected list.
► Open the list with the left function key [Select].
► Use [] / [] to mark the desired language and press
[Select] to activate it.
> The GUI texts appear in the selected language.
► Press [Next] to go to the next page.
3 Set the system time
Option 1: Set the system time manually
► [Time] and [Date] show the current system time.
► Activate [Activate NTP] checkbox.
> Status LED =
► In the [Time] roup, set the desired clock time one
position at a time.
► In the [Date] group, set the desired date one position at a
time.
► Press [Finish] to save the changes and go to the
standard start screen.
154
(→ page 59)).
2016-03-02

Start screen 'Basic settings'

11226
18511