Lamp Stabilizer Board And Exposure Lamp
1. Operation panel (
2. Exposure glass (
p.85 "Exposure Glass/DF Exposure Glass ")
3. Slide the first scanner to a position where the front end of the lamp is visible.
4. Place one hand under the lamp stabilizer board [A] and release the hook [B].
5. Lamp stabilizer board (
6. Press the plastic latch [C] and push the front end of the lamp toward the rear.
7. Lamp [D] (with the cable)
Original Width/Length Sensor
1. Exposure glass (
p.85 "Exposure Glass/DF Exposure Glass ")
p.78 "Upper Covers")
x 2)
Scanner Unit
4
87