Attaching The Stand - Sony DVP-F35P Operating Instructions Manual

12
Press X/x to select whether or
not you wish to send a DTS signal
to your amplifier (receiver).
Choose the item that matches the audio
connection you selected on pages 22 to
24 ( through
B
B-2 C-2
• OFF (page 72)
D
• ON (only if the amplifier (receiver) has
a DTS decoder) (page 72)
13
Press ENTER.
Quick Setup is finished. All connections
and setup operations are complete.
If your AV amplifier (receiver) has an
MPEG audio decoder, set "MPEG" to
"MPEG" (page 72).
Enjoying the surround sound
effects
To enjoy the surround sound effects of this
player or your amplifier (receiver), set the
following items as described below for the
audio connection you selected on pages 22 to
24 ( through
B D
default setting and does not need to be
adjusted when you first connect the player.
See page 66 for using the Setup Display.
Audio Connection (pages 22 to 24)
A
• No additional settings are needed.
B-1 C-1
• Set "DOWNMIX" to "DOLBY
SURROUND" (page 71)
• If the sound distorts even when the volume
is turned down, set "AUDIO ATT" to "ON"
(page 71)
B-2 C-2 D
• Set "DOWNMIX" to "DOLBY
SURROUND" (page 71)
• Set "DIGITAL OUT" to "ON" (page 71)
).
D
). Each of these is the

Attaching the Stand

You can use the player laid horizontally, or in
an vertical position. Be sure to attach the
supplied stand when using in the vertical
position.
1
Fit the projection of the stand into
the slot on the
2
Slide the stand back and forth to
align the screw holes.
Select two screw holes to decide the foot
position.
3
Secure the two supplied screws.
4
Stand the player up.
side of the player.
,continued
27