Sony DVP-F11 Operating Instructions Manual page 55

When you set the TV/DVD switch to TV, you can control
your TV using the keys below.
TV/DVD switch
1 2 3
4 5 6
7 8 9
0
By pressing
You can
1/u (POWER)
Turn the TV on or off
TV/VIDEO Select the input source for the TV
between the TV and VCR
VOL Adjust the volume of the TV
TV CH Select the channel of the TV
Switch the wide picture on or off
WIDE MODE
Note
Depending on the TV, you may not be able to control your TV or
to use some of the buttons above.
Controlling an AV receiver (amplifier)
with the remote
1
1/u (POWER)
2
WIDE MODE
ENTER
TV/VIDEO
TV CH
VOL
ENTER
Code numbers of controllable receivers
(amplifiers)
If more than one code number is listed, try entering them
one at a time until you find the one that works with your
receiver (amplifer).
You can also change the sound volume of the AV receiver
(amplifier) using VOL.
Note
Depending on the AV receiver (amplifier), you may not be able to
control your AV receiver (amplifier).
Slide the TV/DVD switch to DVD.
Hold down 1/u (POWER), and enter your AV
receiver's manufacturer's code (see the table
below) using the number buttons. Then release
1/u (POWER).
Manufacturer Code number
Sony
91, 88, 89
Denon
84, 85, 86
Kenwood
92, 93
Onkyo
81, 82, 83
Pioneer
99
Sunsui 87
Technics
97, 98
Yamaha
94, 95, 96
Sony TVs
90 (default)*
* By setting the code number 90, you can adjust
the volume of the TV even if the TV/DVD
switch is on the DVD side, if you do not control
an AV receiver (amplifier) with the remote.
1 2 3
4 5 6
7 8 9
0
VOL
55