Installation - Ducati R5 Assembly And Use Instructions

4 INSTALLATION

The controller must be installed on a vertical panel on which a square opening in compliance with IEC 61554
standard has been previously made. Opening dimensions must be 92.0mm x 92.0mm, with a permitted tolerance of
+0.8mm and -0mm.
Insert controller from panel front side and secure it
them slide fully home against panel rear wall.
Dimensions
+0.8mm -0mm
92.0mm
For flying connector wiring, refer to
CONTENTS
GO BACK TO
MU-MID-R5-D-ENG.doc
Chap. 5 - CONNECTIONS
at the back with the 4 supplied retaining clips, letting
Dimensions
+0.8mm -0mm
92.0mm
.
Page6 of 70