Power Cord Specifications - Cisco Secure Network Server 3600 Series Hardware Installation Manual

Server Specifications
DC Input Voltage
Maximum DC input current
Maximum input wattage
Maximum inrush current
Maximum hold-up time
Maximum output power per PSU
Power supply output voltage
Power supply standby voltage
Efficiency rating
Form factor
Input connector

Power Cord Specifications

Each power supply in the appliance has a power cord. Standard power cords or jumper power cords are
available for connection to the appliance. The shorter jumper power cords, for use in racks, are available as
an optional alternative to the standard power cords.
Note
Only the approved power cords or jumper power cords listed below are supported.
Table 10: Supported Power Cords
Description
CAB-48DC-40A-8AWG
DC power cord, -48 VDC, 40 A, 8 AWG
Three-socket Mini-Fit connector to three-wire
CAB-C13-C14-AC
AC power cord, 10 A; C13 to C14, recessed receptacle
Nominal range: -48 to -60 VDC
(Range: -40 to -72 VDC)
32 A at -40 VDC
1234 W
35 A (sub-cycle duration)
5 ms at 100% load (1050 W main and 36 W standby)
1050 W on 12 VDC main power
36 W on 12 VDC standby power
12 VDC
12 VDC
≥ 92% at 50% load
RSP2
Fixed 3-wire block
Length
(Feet)
11.7
9.8
Cisco Secure Network Server 3600 Series Appliance Hardware Installation Guide
Length
(Meters)
3.5
3.0
Power Cord Specifications
31