Faults And Alarms; Overview Of Fault And Alarm Causes; Acknowledgement Of Faults Or Alarms - fafnir SEPARIX-Control CT Technical Documentation Manual

4.4

Faults and alarms

In case of a fault or an alarm the factory-set SEPARIX-Control CT triggers with the buzzer
an audible alarm signal. In case of a fault, additionally the yellow fault LED blinks, and with
an alarm, additionally the red alarm LED blinks.
4.4.1

Overview of fault and alarm causes

Figure :
7 SEPARIX-Control CT, fault and alarm display
Blink code
1x short
2x short
3x short
4.4.2

Acknowledgement of faults or alarms

Press red acknowledge button.
•
The fault or alarm is acknowledged and the buzzer stops. The yellow or red LED
continues to blink because the cause of the fault or alarm has not yet been cor-
rected.
Faults and alarms are repeated every 24 hours after they have been
acknowledged (red acknowledge button pressed) so that they are
brought to the system operator's attention again.
Page 17/37
Power LED (green)
Interface sensor
High-level sensor
Interface sensor and
high-level sensor
1: Power LED (green)
2: Fault LED (yellow)
3: Alarm LED (red)
4: Acknowledge button (red)
5: Test button (yellow)
Fault LED (yellow)
Interface sensor
High-level sensor
Interface sensor and
high-level sensor
SEPARIX-C/-T and SEPARIX-Control CT
Alarm LED (red)
Oil layer
High level
Oil layer
and high level