Setting Up The Hardware (Assembly) - Siemens SIMATIC S7-200 Manual

Setting up the Hardware (Assembly)

Base plate
1. Mount the enclosed mounting rail on a base plate as shown in the drawing.
S7-200
CPU
2. Mount the simulator on the input terminal block of the S7-200.
The input terminal block is the terminal block on the underside of the PLC.
3. Snap the assembled PLC onto the mounting rail from above.
4. Snap the training model (part of the starter kit) onto the mounting rail
next to the PLC.
Hardware
Software
Mounting rail
Simulator
Basic 1st Exercise
Settings Programm
Training model
More
Appendix
Exercises
5