Downloading The 1St Exercise Program - Siemens SIMATIC S7-200 Manual

Downloading the 1st Exercise Program

Click this icon with the mouse to switch the PLC to STOP mode when the mode selector
on the PLC is set to TERM or RUN and the PLC was in RUN mode (LED STOP lights
up).
Caution: This action means that a connected machine is no longer controlled.
Click this icon with the mouse to download the (open) program, which is displayed on
the monitor, onto the PLC.
Click this icon with the mouse to switch the PLC to RUN mode when the mode selector
on the PLC is set to TERM or RUN and the PLC was in STOP mode (LED RUN lights
up).
Caution: A connected machine may start moving immediately, depending on the
effect of your program.
You can also load a program from the PLC onto your programming device/PC.
Click this icon with the mouse to upload the program on the PLC onto the programming
device/PC. It overwrites the program currently displayed on the monitor.
You should therefore always make sure that you always have a current version of your
program on the hard disk or diskette when you leave a plant.
Hardware Software
Basic 1st Exercise
Settings Program
It is only possible to
transfer a program to the
S7-200 in STOP mode !
Warning
!
Danger of injury
and material damage.
More
Appendix
Exercises
21