Operation; Getting Ready For Operation; Commissioning - MICRO-EPSILON ELTROTEC Endolight FOT Halogen 150 Instruction Manual

Operation

5.
5.1
Check the built-in heat filter for possible break.
NOTICE
> Damage to the iris diaphragm and the connected fiber optics by excessive heat development
i
5.2
The light source is supplied as standard for the connection to 230 VAC operating voltage, see Chap.
i
Some fiber optic cables (e.g. multi-armed gooseneck fiber optic cables) and adapters are fitted with a cam
(anti-rotation device), which enters the anti-rotation device keyway (4), see Chap. 4.2, to prevent rotation of
the connector.
The control lamp lights up. The light source is ready to operate.
Check Always after switching on whether the built-in fan runs (noise).
NOTICE
> Destruction of the lamp, the heat protection filter and the iris diaphragm due to excessive heating.
i
ELTROTEC Endolight FOT Halogen 150
Operation

Getting Ready for Operation

Set the iris diaphragm control lever (3), see Chap. 4.2, initially at minimum position (left) to prevent
glare.

Commissioning

Replug the voltage selector (8) for 110 VAC operating voltage by setting the
row (8), see Chap. 5.3.
The terminals 120 Volt (positioning arrow (2) is on
250, see Chap.
ing arrow (2) is on
If the voltage selector has this setting, the light source can therefore not be used.
Connect the supplied power supply cable to the power input (9), see Chap.
Connect the fiber optic cable to the fiber optic connection (5), see Chap. 4.2.
ON OFF
Press the / switch (7), see Chap. 4.2.
In case of a defective fan, turn the light source off immediately.
125, see Chap.
5.3
.) are not occupied and cannot be used.
A 3.
115
to the positioning ar-
5.3
.) and 240 Volt (position-
4.2 and the power supply.
Page 12