4
MasterShunt 500 – User and Installation manual
2 SAFETY INSTRUCTIONS
WARNING!
Read the entire manual before using the MasterShunt 500. Keep this manual in a secure place.
Installation and work on the MasterShunt 500 may be carried out only by qualified and trained personnel, consistent with the
locally applicable standards and taking into consideration the safety guidelines and measures.
2.1
Use for intended purpose
The MasterShunt 500 is constructed according to applicable safety guidelines.
Use the MasterShunt 500 only:
in a technical correct condition;
in a closed, well-ventilated room, protected against rain, moist, dust and condensation;
observing the instructions in the user manual.
WARNING!
Never use the MasterShunt 500 in locations where there is danger of gas or dust explosion or potentially flammable
products.
2.2
Maintenance and repair
If the electrical installation is switched off during maintenance and/or repair activities, it should be secured against unexpected
and unintentional switching on:
switch off all charging systems;
switch off the connection with the batteries;
be sure that third parties cannot reverse the measures taken.
If maintenance and repairs are required, only use original spare parts.
2.3
General safety and installation precautions
Connection and protection must be done in accordance with local standards.
Do not work on the MasterShunt 500 or system if it is still connected to a current source. Only allow changes in your
electrical system to be carried out by qualified electricians.
Check the wiring at least once a year. Defects such as loose connections, burned cables etc. must be corrected
immediately.
2.4
Warning regarding battery use
Excessive battery discharge and/or high charging voltages can cause serious damage to batteries. Do not exceed the
recommended limits of battery discharge level. Avoid short circuiting batteries, as this may result in explosion and fire hazard.