Table of Contents
Advertisement
5 SETTINGS
The MasterShunt 500 can be monitored from a display like the Touch 10 (in a CZone network) or the EasyView 5 (in a
MasterBus network). Some settings can only be adjusted from a laptop/notebook or PC connected to the MasterShunt 500 via
a USB Interface.
5.1
About MasterBus
MasterBus is a CAN based, data network for communication between Mastervolt devices. The main connection to communi-
cate with each MasterBus interface is MasterAdjust. MasterAdjust software is available as free to download software on the
Mastervolt website: www.mastervolt.com. This tool runs on a Windows PC/notebook. Another option is to use a control panel
such as the EasyView 5.
When the MasterShunt 500 is connected to MasterBus, open MasterAdjust. The MasterShunt 500 will be recognized by the
MasterBus network automatically. The following sections use the screens as shown in MasterAdjust.
At first start up, MasterAdjust will guide you through the following settings:
Figure 4: First start up
If you want to want to make changes afterwards, go to the Configuration tab make the required changes and press Reset
setup. See section 5.1.1.
5.1.1
Configuration
The following sections describe the settings as shown in MasterAdjust. With the CZone configuration tool, some of these
settings are found under Advanced Settings or under Alarm/Switch Settings.
Variable
General
Language
Name
Year
Setting
Select the language of
MasterAdjust.
Set the battery capacity to enable
the MasterShunt 500 to calculate
the state of charge.
Four different battery types can be
selected. The spiral battery
belongs to the AGM batteries.
Nominal battery voltage, set at
first set up.
Use this option for reversing input
and output, when you installed the
load at the left of the MasterShunt
500.
Use this option for parallel or
single device configuration.
"I + U only" monitors the current
and voltage only.
Check your settings and confirm by pressing Finish setup. Modification of the
settings afterwards requires a reset of the setup. See section 5.1.1.
Meaning
Change the language used in
MasterAdjust.
Name of the battery bank..
Set the MasterShunt 500 clock
year.
MasterShunt 500 – User and Installation manual
Default
English
Value from
First Setup
Value from
First setup
Value from
First setup
Off
Single
device
Factory setting
English
MasterShunt 500
2000
Range
English, Nederlands,
Deutsch,
Français,
Castellano, Italiano, Norsk,
Svenska, Suomi, Dansk.
30-10000Ah
Flooded, Gel, AGM, MLI.
12V ,24V, 48V
Off, On
Single device,
I + U only,
Parallel mode.
See also chapter 4.5
1)
Range
Notes
English,
MasterBus
Nederlands,
(MB) only
Deutsch,
Français,
Castellano,
Italiano, Norsk,
Svenska, Suomi,
Dansk.
Any maximum
12 character
name.
2000-2135
MB only
11
Hide quick links:
Advertisement
Table of Contents
