Table of Contents
Advertisement
• Use:
For mixing/stirring liquids with low and high viscosities by vari-
ous stirring tools.
Intended use: Stand device (chuck points down).
• Range of use (indoor use only):
- Laboratories
- Pharmacies
• Wireless remote control:
Before using the wireless link between the WiCo and the labo-
ratory device, first check whether your region is included in the
radio communications approval for the device. If it is not, remote
control can also be performed using a USB cable.
• Unpacking:
- Unpack the device carefully.
- Any damage should be notified immediately to the shipping
agent (post, rail or logistic company).
• Delivery scope:
- EUROSTAR 100 P4 control station with a WiCo
- Extension arm
- Hexagonal socket screw
- Hexagon socket offset screw key
- Chuck key
- Pt 1000 temperature sensor
- Protective cover
- WiCo holder
- OS 1.0 power supply unit
- USB 2.0 cable micro A – micro B
- USB 2.0 cable A – micro B
- User guide
- Warranty card
The rotary knob (B, see Fig. 1) of the WiCo allows the speed of the stirrer to be adjusted over the entire speed range.
The stirring device is suitable for continuous operation. The motor
current is limited electronically. The device has an anti-stall and
anti-overload system.
Speed - regulated (no variation in speed):
The speed is monitored and regulated by processor controlled.
The target speed is constantly compared with the actual rota-
tion speed value of the output shaft and variations corrected. This
guarantees a constant speed even if the viscosity of the substance
being stirred changes.
- Schools
- Universities
Motor protection
Speed – normal operation
Correct use
This device is suitable for use in all areas except:
- Residential areas
- Areas that are connected directly to a low-voltage supply net-
work that also supplies residential areas.
The safety of you cannot be guaranteed:
- If the device is operated with accessories that are not supplied or
recommended by the manufacturer
- If the device is operated improperly or contrary to the manufac-
ture's specifications
- if the device or the printed circuit board are modified by third
parties.
Unpacking
OS 1.0 power supply unit (for WiCo):
Adapter
Europe, Switzerland
Adapter
England
Drive
If a fault occurs, a safety circuit immediately switches off the mo-
tor permanently through a relay in the power board. A fault occurs
if the safe functioning of the device is compromised.
Fluctuations in mains voltage within the permitted tolerance range
have no effect on the quality of regulation and constancy of speed.
The speed is set using the front knob (B, see Fig. 1). During normal
operations the speed value on the display (C, see Fig. 1) corresponds
to the speed of the output shaft in revolutions per minute (rpm).
Adapter
USA, China
Adapter
Australia
6
Advertisement
Table of Contents
