IRIS Touch 2 Engineering Manual page 18

Settings
Network Interfaces
Account Name/Number
ARC IP Address
Dialler IP Address (IRIS Touch 220NG or 240NG)
Page 18 of 36 IRIS Touch
The Settings option is used to configure additional settings required for installation or
additional options that may be added at a later date. Below is a detailed description of
all of these options.
This section allows the user to select the communication paths to be used for polling /
alarms on a multipath IRIS Touch dialler. There are up to 2 options as detailed below,
depending on which version of IRIS Touch dialler:

Ethernet

GPRS/3G (Machine to machine data 'M2M')
Set the account name/number for the IRIS Touch unit on site, as allocated by the
monitoring centre.
Set up the external IP address for the monitoring centre receiver (polling engine).
Note: Only the primary/main ARC IP address needs be entered on the dialler as all
backup or alternative IP addresses, for the ARC are downloaded to the IRIS Touch
dialler on the first polling communications.
Allows the user to setup the IP address of the dialler to either automatic (DHCP) or a
fixed IP address. The settings below will either show the IP address received (DHCP
mode) or, if fixed, allow the user to set the IP address, subnet and gateway:

IP Address

Subnet Mask

Gateway

Mac Address (view only)
Engineering Manual Version 1.5