Table of Contents
Advertisement
3.2 Installation of the hand release (29) (brakes types with hand release)
The lever of the hand release (29) must be inserted into the square socket of the two cams (29.1) which are
firmly fitted to the circumference of the solenoid housing (1.1). Make sure the lever is correctly positioned.
The mechanical release forces F and the maximum permitted release forces (actuation forces) F
specified in Table 8/1.
Note!
Machinery-specific regulations and requirements (e.g. for hoists, cranes and elevators) must be observed
when using brakes with hand release (29). The hand release (29) must not be used to release the brake
during normal operation.
Caution!
The brake torque can be neutralised manually by means of the hand release feature (29). Consequently, the
brake must be installed in such a way that any unintentional actuation of the hand release (29) is excluded
and reliable brake operation is ensured.
Release force F [N]
Max. permitted release force F
Table 8/1: Release force F, max. permitted release force F
Warning!
Check that the mechanical hand release (29) is in a central position (see Fig. 6/1) when not in use. This is
crucial to ensure reliable brake engagement. Otherwise, the full braking effect of the spring-applied single-
disc brake may not be reached. In this case, the machine (e.g. motor) must be stopped immediately and
must not be restarted until correct operation of the hand release (29) and automatic return of the hand
release lever in its central position (see Fig. 6/1) has been ensured.
Kendrion Binder Magnete GmbH
10
approx. 18
approx. 35
[N]
50
max
Operating Instructions 76 ..P..B00
Size
11
13
approx. 45
approx. 90
50
125
of hand release (29)
max
Last updated: 30 Dec. 2009
16
19
approx. 85
approx. 170
125
240
are
max
24
240
Page 8
Advertisement
Table of Contents
