Sump Gasket; Installing Sump Module - GE DDT595SxJ0 Series Technical Service Manual

Sump Gasket

Stressing or softening the gasket ribs (see below) will
make a new gasket seat easier. Lubricating with a
small amount of rinse agent or water will also ease
installation.
Single Use Clamp Removal Tip: Use a small
screwdriver inserted into the ear of the clamp and
move the handle back and forth to loosen the
clamp. The clamp can be removed and discarded
when the component is removed.
WARNING: Using diagonal pliers to cut clamps may
cause damage to the hoses.

Installing Sump Module

While inserting the sump assembly back into the
tub, use care to ensure the sump assembly wiring
and components are not pinched between the
sump and the tub.
NOTE: Using rinse aid or water on the sump gasket
will aid sump installation.
1.
Do not connect the turbidity sensor until after
the sump module is back in place (step 5) to
prevent damage to the connector.
2.
module to the main conduit (see alignment
marking in the step 3 illustration). Some
switch to make adjustments.
3.
down on the sump module.
4. Latch the three sump latch cams. The latch
cams must not be used to pull the sump module
into place.
5. Connect the turbidity sensor and high drain loop
hose.
– 42 –