Sump Module - GE DDT595SxJ0 Series Technical Service Manual

Sump Module

The sump module is front serviceable with the
dishwasher remaining in the installed location. This
section of the guide only covers the sump removal.
Components and diagnostics of the sump module
may be found in the Fill System, Circulation System
or Drain System sections of this service guide.
Sump Module Removal
1. Remove power to the dishwasher.
2. Remove the upper and lower racks.
3. Remove the toe kick.
4. Remove the door (see the Door Removal section
of this service guide).
5. Remove the lower spray arm (turn the locking
nut counter clockwise).
6.
(turn counter clockwise to remove).
7. Remove the main conduit (see the Circulation
System section of this service guide).
8. Loosen the high drain loop hose clamp (1/4 in.
hex head) and remove the hose from the drain
pump (there will be a small amount of water in
the sump, pump and hose).
High Drain Loop Hose
9. Disconnect the turbidity sensor wiring (some
models).
Disconnect Turbidity Sensor Harness
10. Unlatch three sump clips. All three latches can
be reached from the front of the dishwasher in
most installations. If the dishwasher does not
have the legs extended, the dishwasher may
have to be removed from its installed position.
– 40 –