GE DDT595SxJ0 Series Technical Service Manual page 24

Full Extension Rails
To remove the upper rack and full extension rails:
1. Extend to the full outward position.
2. Push up on the right side track lever and down
on the left side track lever.
3.
When reinstalling the rack, guide the tracks onto the
rails and push it all the way in to lock it in place.
Rails: The rails are attached to the stainless steel
tub and are a non-replaceable part.
Tracks: Removal of the tracks from the upper rack is
accomplished by removing the one 1/4 in. hex head
screw from the front of the adjustable bracket.
Remove 1/4"
hex head screw
Pull out 1/2 in. and slide the rail toward the front of
the rack, releasing the rail from the rear tab.
1
Adjustable Bracket: To remove the adjustable rack
bracket from the rack bracket:
1. Remove the rack and rail.
2. Place the rack on a protective surface, upside
down.
3. Push in on the adjusting lever to slide it all the
way down.
4.
rack bracket.
Stationary Bracket: The bracket is snapped onto
the rack, and can be removed by pressing in on 4
tabs to release, then sliding the bracket to the front
– 24 –
2