Troubleshooting; Specifications - Sony CDP-XE200 Operating Instructions Manual

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
Check that the player is connected securely.
/
Make sure you operate the amplifier correctly.
/
Adjust the output level with LINE OUT LEVEL +/–
/
on the remote (CDP-XE500 and CDP-XE300 only).
The CD does not play.
There's no CD inside the player ("no dISC" appears).
/
Insert a CD.
Place the CD with the label side up on the disc tray
/
correctly.
Clean the CD (see page 14).
/
Moisture has condensed inside the player. Remove
/
the disc and leave the player turned on for about an
hour (see page 2).
The recording level has changed (CDP-XE500 and CDP-
XE300 only).
The recording level changes if you adjust the output
/
level with LINE OUT LEVEL +/– on the remote
during recording.
The remote does not function (except for CDP-XE200).
Remove the obstacles in the path of the remote and
/
the player.
Point the remote at the remote sensor g on the player.
/
Replace all the batteries in the remote with new ones
/
if they are weak.
Additional Information Additional Information

Specifications

Compact disc player
Laser Semiconductor laser ( = 780 nm)
Emission duration: continuous
Laser output Max 44.6 W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response
2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio More than 100 dB
Dynamic range More than 98 dB
Harmonic distortion Less than 0.0045%
Channel separation More than 95 dB
Outputs
Jack Maximum
type output
level
LINE OUT Phono
2 V
jacks
(at 50 kilohms)
DIGITAL
Optical
–18 dBm
OUT output
(OPTICAL)
connector
(CDP-XE500
only)
PHONES
Stereo
10 mW
(CDP-XE500
phone
only) jack
General
Power requirements 220 V – 230 V AC, 50/60 Hz
Power consumption 10 W
Dimensions (approx.) 430
(w/h/d)
(17
parts
Mass (approx.) CDP-XE500: 3.0 kg (6 lbs 10 oz)
CDP-XE300/XE200: 2.9 kg (6 lbs 7 oz)
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Remote commander (remote) (except for CDP-XE200) (1)
Sony SUM-3 (NS) batteries (except for CDP-XE200) (2)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Wave length: 660 nm
32 ohms
95 295 mm
3 3/4 11 5/8 in.) incl. projecting
15
EN