Sony CDP-XE200 Operating Instructions Manual page 5

You can adjust the output level to the amplifier
(CDP-XE500 and CDP-XE300 only)
Press LINE OUT LEVEL +/– on the remote. You can
reduce the output level up to –20 dB.
When you reduce the output level,
display.
When you turn off the player, the output level
automatically returns to the maximum level.
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD (CDP-XE500 only)
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
Note that you cannot use the following functions when
making this connection:
• Fading in or out (see page 13)
• Time Fade (see page 13)
• Adjusting the output level using the LINE OUT LEVEL
+/– buttons on the remote (see above)
POC-15
Optical cable (not supplied)
CD player
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software other
than music, such as a CD-ROM.
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
appears in the
Where do I go next?
Now you're ready to use your player.
If you aren't familiar with how to play CDs, go to the section
"Playing a CD" on page 6.
Then, go to the following sections for other operations.
Digital component
Getting Started
Getting Started
5
EN