Suzuki SY413 Service Manual page 4565

Engine oil capacity
Oil pan capacity
(10.6/8.8 US/Imp pt.)
Oil filter capacity
(0.4/0.3 US/Imp pt.)
Others
(0.6/0.5 US/imp pt.)
Total
(11.6/9.6 US/Imp pt.)
62G00-0B-7-1S
1 3
1. Radiator cap 3. Reservoir tank hose
2. Clamp 4. Inlet hose
62G00-0B-7-2S
1. Full level mark
2. Low level mark
62G00-0B-7-3S
62G00-0B-7-4S
2
1. Radiator
2. Radiator drain plug
62G00-0B-7-5S
about 5.0 liters
about 0.2 liters
about 0.3 liters
9) Check oil filter and drain plug for oil leakage.
about 5.5 liters
ITEM 1-3
2 4
Cooling System, Hoses and Connections Inspection
1) Visually inspect cooling system hoses for any evidence of leakage
2) Replace all hoses which show evidence of leakage, cracks or other
62G00-0B-8S
3) Clean frontal area of radiator core.
4) Test system and radiator cap for proper pressure holding capacity,
5) Check coolant level and concentration.
62G00-0B-9S
ITEM 1-4
Engine Coolant Change
1) Remove radiator cap when engine is cool.
2) Loosen radiator drain plug to drain coolant.
3) Remove reservoir tank and drain.
4) Tighten drain plug securely. Also install reservoir tank.
5) Fill radiator with specified amount of coolant, and run engine for 2
1
62G00-0B-10S
NOTE:
Engine oil capacity is specified as left table.
However, note that amount of oil required when actually
changing oil may somewhat differ from data in left table de-
pending on various conditions (temperature, viscosity, etc.).
and cracks. Examine them for damage, and check connection
clamps for tightness.
damage. Replace all clamps which cannot maintain proper tight-
ness.
2
110 kPa (1.1 kg/cm , 15.6 psi).
If replacement cap is needed, use a cap designed for cooling sys-
tem of this vehicle.
Add if necessary.
Refer to COOLANT LEVEL of SECTION 6B for procedure of level
check.
WARNING:
To help avoid danger of being burned, do not remove radia-
tor cap while engine and radiator are still hot. Scalding fluid
and steam can be blown out under pressure if cap is taken
off too soon.
or 3 minutes at idle. This drives out any air which may still be
trapped within cooling system. STOP ENGINE. Add coolant as
necessary until coolant level reaches filler throat of radiator. Rein-
stall radiator cap.
MAINTENANCE AND LUBRICATION 0B-7