Suzuki SY413 Service Manual page 4392

1. Speedometer driven gear (Vehicle speed sensor
for speedometer) shaft sleeve subassembly.
60G40-7B1-45-1
1. Shift switch 4. Lock nut
2. Bolt 5. Manual shift lever
3. Lock washer
60G40-7B1-45-3
60G40-7B1-45-4
60G40-7B1-45-5
76) Coat new O-ring with A/T fluid.
77) Tighten speedometer driven gear (vehicle speed sensor for
speedometer) (with new O-ring installed) with bolt.
Tightening Torque
(a): 5.5 N·m (0.55 kg-m, 4.0 lb-ft)
78) Install transmission range switch assembly.
a) Place new rubber plate and new lock washer or shift switch.
b) Tighten lock nut.
Tightening Torque
(a): 7.0 N·m (0.7 kg-m, 5.0 lb-ft)
c) Adjust transmission range switch.
d) Tighten transmission range switch bolts.
Tightening Torque
(b): 20 N·m (2.0 kg-m, 14.5 lb-ft)
e) Tighten manual shift lever with spring washer and nut.
Tightening Torque
(b): 20 N·m (2.0 kg-m, 14.5 lb-ft)
79) Install oil cooler pipes.
Tightening Torque
(a): 27 N·m (2.7 kg-m, 19.5 lb-ft)
(b): 25 N·m (2.5 kg-m, 18.0 lb-ft)
NOTE:
Make sure to use new A/T fluid pipe union bolt gaskets to
prevent fluid from leaking.
1. Oil cooler pipe
2. New gasket
80) Measure starting torque of differential gear assembly.
For detail, refer to step 2) on REMOVAL procedure.
AUTOMATIC TRANSMISSION (4 A / T) 7B1-45