Suzuki SY413 Service Manual page 4397

8-4 BODY ELECTRICAL SYSTEM
COMBINATION SWITCH
Combination switch incorporates lighting, turn signal, hazard warning light, dimmer, passing light and wiper/wash-
er switches and steering angle sensor.
TURN
D Terminal arrangement of combination switch
coupler viewed from harness coupler.
60G40-8-4-3
60G40-8-4-4
60G40-8-4-5
INSTRUMENTS AND GAUGES
DIMMER & PASS
LIGHT
To J / B
Inspection
1) Disconnect negative (–) cable at battery.
2) Disconnect combination switch lead wire connectors from junc-
tion/fuse box.
3) Use a circuit tester to check the continuity at each switch posi-
tion. If any continuity is not obtained, replace switch.
Removal/Installation
For removal/installation of combination switch, refer to Section 3C
or 3C1 of manual mentioned in FOREWORD of this manual.
NOTE:
Some vehicles are not provided with INTERMITTENT position
depending on specification.
WIPER
WASHER
REAR WIPER &
WASHER
A. Horn switch
B. Air bag inflator (if equipped)
C. Steering sensor (if equipped)